100k Potentiometer Through Hole LED It is compatible with Arduino

It is compatible with Arduino IDE and NodeMCU firmware Chip: ESP-8266EX Compatible with Arduino IDE Compatible NodeMCU firmware GPIO pins: 11 1 pin ADC (0 V to 3

Any two points the distance more than 3m transmission signal without any increase circuit

Use this to build powerful and efficient quadcopters

Used in wide Applications PC motherboard

6500-7000k

100k Potentiometer Through Hole LED It is compatible with ArduinoThe 100K Pot Potentiometer is a three terminal variable resistor that is used to vary or change the resistance. It is used to change different parameters in an electronic circuit, such as voltage, current, and so on. The 100K POT Potentiometer is a passive electronic component that has two end terminals with a resistive element and the sliding contact called the wiper acts as the third terminal. Two other terminals present are used to facilitate