S-Chassis K-Frame/Caster mount weld in reinforcement plates Pivot Balls or at all if extended

or at all if extended too far out)

The lengths on these arms are fully adjustable and with the right adjustments

They eliminate axle tramp whilst also raising the subframe 10mm which helps to correct the roll center on lowered vehicles

When tested on a dyno the GKTECH high-performance fan took less than half the time to cool down from 90 degrees to operating temperature (good for next time you're on the start line at the track)

- Uses high quality PTFE lined 1 5/8" high misalignment rose joints

S-Chassis K-Frame/Caster mount weld in reinforcement plates Pivot Balls or at all if extendedThe GKTech weld in K frame caster rod plates has been designed to help brace one of, if not the most necessary area on your S chassis. Caster rods put an immense amount of load on the K frame and the K frame itself flexes under load a visually noticeable amount. Our weld in plates will help eliminate this which will result in better overall handling and steering feedback. The added benefit is that if you ride over a ripple strip at the race track (or